Interact with Target

Hello,
I was hoping you could help me to get IWT without turning "Do Click to Move On". I hate this as it leaves it on while in combat and my toons may end up running to where I click, especially when using repeater regions.
My configuration can be found here: Paste ID e4e39eeb54.

Thank you

[Ualaa]

The wizard generated IWT/CTM will work, if you manually push it.

It is a two step mapped key.
Executing an action on both push and release.

Push enables Click to Move.
Release disables Click to Move.
The IWT comes after CTM is turned on, and before CTM is turned off.

You have to manually push the mapped key each time.
But you don't have CTM enabled, so even if you click somewhere your toon won't go running off (nor will the slaves if you click their screen(s) while Repeater is enabled).



If you want to "imbed" IWT into your DPS keys, then you'll need to leave CTM enabled.
This is because the IWT is done on a single step, as part of your DPS.
Rather than as two steps.
You can toggle whether the imbedded IWT is enabled or not.

My IWT setup follows the imbedded route: http://www.dual-boxing.com/showpost.php ... ostcount=3