FAQ  •  Register  •  Login

How to manage Follow hotkey with and without mercs

Moderator: MiRai



Posts: 67

Joined: Sun Oct 03, 2010 1:22 pm

Post Mon Dec 04, 2017 4:01 pm

How to manage Follow hotkey with and without mercs

I have 3 toons and normally run without mercs, so the wizard follow setup works just fine. However, if I switch to using Mercs, the key to target a group member changes, so I end up running the wizard all over again, since I can't seem to find where the info from the wizard is stored. Is the best option to switch to using macros on each character to target other group members? Seems clunky, but I'm not sure how else to handle this... Advice?


User avatar

Vibrant Videographer

Posts: 2908

Joined: Fri Nov 20, 2009 3:30 pm

Post Mon Dec 04, 2017 7:37 pm

Re: How to manage Follow hotkey with and without mercs

The F-key targeting grid uses Variable Keystrokes, and can be found under the Variable Keystrokes tab of each Slot of your Character Set.

As for options, not knowing a whole lot about EQ2, I would assume:

    1) Manually change them whenever using mercenaries either through ISBoxer (permanent - persists through ISBoxer exports), or through the in-game GUI (temporary - doesn't persist through ISBoxer exports).

    2) Create a second Character Set with the F-key targeting grid altered to reflect that mercenaries are in your party. This option assumes that these values are static when the mercenaries are present.

    3) Use macros with hard-coded character names.

Return to EverQuest 2

Who is online

Users browsing this forum: No registered users and 1 guest