Need help with autorun

Ok. Super extra thanks for everyone at IsBoxer hanging in there with me while I got this figured out. In the end I had trouble getting Logitech's Setpoint software to work running as Admin, so I disabled UAC and now all is good. Of course, I don't see this as a permanent solution and would not recommend it as UAC is an important security measure. However, it was a solution. If I can make progress running SetPoint as Admin I will report back.

Thanks!

-Sierra

Hello,

Well, I just got off the phone with Logitech who were helpful after I gave them all of the model and part numbers they could ask for. Basically, they said that they usually recommend that Windows Seven 64-bit users disable UAC for use with their mice.

So, I guess that is my lot for now. Good news is Auto Run now works well from my mouse button

-Sierra

p.s.- For those who might be wondering, I also tested each level of UAC and the mouse and Setpoint software only worked properly with Innerspace with UAC turned completely off.