Problem with mouse broadcasting

[diaz06]

Hello,

I post this message because i need help about mouse broadcasting. When i enable it, the mouse of main Windows is not at the same position as other windows. How to solve this issue please ?

Thanks you

[bob]

Depends on the game.

But the usual culprits are:

• Your window layout is using different resolutions for each game, rather than using the Instant Swapping option. This might be because you chose to disable swapping in the Window Layout Wizard (swapping can be disabled in other ways while still synchronising the resolutions).
• Your window layout is using different aspect ratios between the window regions
• Your game is using different window modes, like Fullscreen and Windowed . You should be using Windowed or Windowed Fullscreen if the game has it. Sometimes you might need to set Fullscreen and then go back to Windowed afterwards for the game to set the correct resolution (Note: It would really help to know what the game is here as some games you might be required to go against the grain and actually set Fullscreen, but these are few and far between so this is more a general recommendation).

If you cant resolve it, please post a copy of your config.

[diaz06]

Hello,

The game is WoW.
The games have all the same resolution and ratio, the window mode is same for all. Swapping is enabled.

The config is here : http://pastebin.com/jVBrkXVG

It is for the "DruidTeam" set.

Thanks you a lot.

[bob]

You have unselected the option to use Instant Swapping, which synchronises resolutions (the internal render size of the game, not necessarily what is actually displayed on your screen). I imagine this might be because you don't have enough GPU power to run 5 instances of the game at near enough 4K resolution.

If you use different render sizes, then yes, the mouse position will be off, because mouse position 1000,1000 on your main window is off the screen in the smaller windows which are using the resolution of 960,342.

So, you can either tick the Instant swapping option, if you have the GPU power, or you can select Repeater Profiles -> Default, and set the Cursor Positioning Mode to one of the "Scaled to fit..." options.

[diaz06]

Hello,

Thanks you a lot, my problem is solved.