Following issue

So I am very new to using this software and am having a bit of a time getting my other toon to follow my main toon. I downloaded the Jamba addon, but when I have it loaded on both toons the slave toon wont follow the master, yet when I switch to the slave toon the master will follow. I decided to just turn off Jamba to see if this worked and it does. Both toons will now follow one another depending on which screen I have up. The problem I have with this though is that both are monks so when I get into combat the the toon that was on follow will stop following. This kinda puts me in a pickle when the mob wont sit still, so in the end I am really only fighting with one toon thus defeating the purpose of why I am trying out this software. I did a little reading and everyone is saying to turn on Jamba as well as strobing. I did this, but this takes me back to the same problem I had with Jamba.

Point is, I want to use Jamba, but I need my slave monk to follow my master monk in everything. So before we fight, follow, during fight, follow, after fight, go back to follow and rinse and repeat. As I said, I have very little knowledge on either of these and that is why I am having this problem I am sure. Oh , is it normal for the Jamba options to not show up on the slave toon? I just want to REALLY try this out, and I think I could really love it, but I need to get these issues fixed so I can love it. Any help would be great.

Thanks

[Ualaa]

Not sure on your follow issue, but you'll likely want to implement IWT+CTM for combat.

IWT = Interact With Target.
This is a keybind, found via: Escape > Keybindings > Targeting Functions (which is 1/3rd of he way down).
Set a keybind for IWT.

CTM = Click to Move.
This is an Option: Escape > Interface Options > Mouse Options > Check the box.



The wizard should give you a default IWT/CTM.
This is a two step mapped key.
Press will enable CTM, and have the slaves assist the main.
Release will send your IWT keybind and disable CTM.

You basically manually push this.
If you didn't have an IWT keybind set, when the team was generated and macros were made, you'd have to edit this mapped key in the IS Boxer Toolkit so it sends your IWT keybind.
Target a mob.
Push the hotkey.
Have your toons run towards the mob, and initiate auto-attack.
Then do any macros/keybinds/etc...
If the mob moves, press the key again.



You can also imbed IWT into your DPS spam.
This is a little more involved... You need to CTM on all the time, so cannot use the mapped key generated by the wizard.

Basically your spam DPS key, which has the slave assist the main...
That also sends IWT to your windows, so the slaves (melee ones) move to the target.

You can toggle it on and off.
When its on, melee will run to the target to kill it.
When its toggled off, the IWT is not sent.

http://www.dual-boxing.com/threads/3414 ... post312469