ISBoxer Profile, Will it work when upgrading G15 to G510?
Moderator: MiRai
5 posts
• Page 1 of 1
I just purchased a Logitech G510 and was wondering if the profile that I created for the Logitech G15 would transfer over as its setup using the G1 thru G6 and also using the M keys including the MR. Or am I going to have to delete those and create them again?
Re: ISBoxer Profile, Will it work when upgrading G15 to G510?
Unfortunately you will need to manually switch the keys over. Inner Space uses different naming per device to avoid conflcits if you wanted to, say, plug in both of them for some reason. The G510 buttons are prefixed with G510-, like G510-G1 through G510-G18 and G510-M1 thorugh G510-MR.
I've gone through the same thing a few times myself, perhaps there is something I can do Creo also mentioned something about a tool for generating alternate hotkeys for Mapped Keys, for this same purpose.
I've gone through the same thing a few times myself, perhaps there is something I can do Creo also mentioned something about a tool for generating alternate hotkeys for Mapped Keys, for this same purpose.
Re: ISBoxer Profile, Will it work when upgrading G15 to G510?
That would be awesome if you had something that could help migrate the keys over.
For now sounds like I will be busy tonight. Shouldn't take me too long. For now its only the mapped key part I have to change or do have to rebuild action to it as well?
For now sounds like I will be busy tonight. Shouldn't take me too long. For now its only the mapped key part I have to change or do have to rebuild action to it as well?
Re: ISBoxer Profile, Will it work when upgrading G15 to G510?
It can't be used anywhere inside your Mapped Key's Steps, can't be broadcasted, etc. So it's mostly just the Hotkeys for Mapped Keys
Re: ISBoxer Profile, Will it work when upgrading G15 to G510?
Good, That shouldn't take very long to change out. I think I have something like 30 keys then to remap.
5 posts
• Page 1 of 1
Return to Lord of the Rings Online
Who is online
Users browsing this forum: No registered users and 0 guests