ISboxer Control Panel is slow in Eve after Rhea Patch

Have you noticed the response ISboxer Control Panel has lagged by 10X what it use to be? I have a lot of video FX windows so it always lagged a bit. After this new Rhea patch though, it feels like the game is slower, and the ISboxer Control Panel's response is very slow.

I opened a single session of Eve seem to work fine. I also multiboxed 4 accounts of Diablo III to see if it was lag or issues on my end.. No issues.

Anyone else having lag issues with Eve under ISboxer? I wonder if CCP is running some kind of monitoring software...

[bob]

EVE always lagged in the ISBoxer COntrol Panel if you were in DX11 mode.

I run 42 active videofx viewers at a time with no noticeable lag (24 on a dxnothing, 18 on the active slot). How many is a lot?

edit: can't count

Believe I have about 30. Well the lag is really bad after Rhea. It takes me 20-30 seconds to choose a different Video FX Set. It use to only take a few seconds.

Think I figured it out. Uncheck the "Enable window blur" in General Settings.

Game seems to respond a little better. If I find out more I'll reply again. (^_^)

[bob]

Try using DX9 mode if you are not already (or continue unchecking DX11 features )

You can set it in the executable parameters by putting "/noconsole /triPlatform=dx9" in the game profile http://isboxer.com/wiki/Game_Profile

Thanks Bob. I'll check that too (^_^)

I'm experiencing this issue as well.

I tried the dx9 parameter and the results are the same.

I only have 12 viewers and 3 sources on my active slot and it's practically impossible to make modifications. To recreate what I have would probably take 2 hours by the time you wait around for the mouse clicks to sync up with the windows.

This seems to be a viewer issue. I can put as many sources on as I want, but as soon as I add a single viewer to the active slot performance craps out.

This is only while in the control panel window. While gaming there are no issues at all.

I have a correction:

When I launch the game and hit ctrl-f it still shows I'm using DX11. The DX9 parameter doesn't seem to be working.

I've attached my inner sphere config (.jpg) to show you where I made the dx9 change.

[Shadowandlight]

put the dx9 argument 1st. see if that works

/triPlatform=dx9 /noconsole

still didn't work. ctrl-f still shows dx 11. I changed the settings hit apply and tried to launch and when that still showed dx11 i rebooted, verified the parameters and launch still with no success. This sucks cause my 11 man fleet is seriously gimped I'm missing a lot of useful videofx panels. I may try creating a videofx screen that is sized to the size of the large panel I want on my active slot and put all the viewers on that and put that on my active slot...that might be an ok workaround.