I have a 7 day trial to test this thing out so perhaps this is a trial period limitation?
I have two machines on the same LAN, no firewall enabled on either machine. They are connected through a switch. Both machines are running Windows 7.
I have followed the instructions on how to use Multiple Computer Helper but it doesn't detect the other computer and I see no network traffic on ports 10101 nor 10102, I'm using WinDump on both boxes. I can see other network traffic between them (eg InputDirector works fine and I can see its traffic) just nothing on the ports that this is supposed to use.
I have been through clean starts of both machines, reboots etc. I've left it sitting for about half an hour to see if it starts up after a while. Nothing.
Here are the instructions I used: http://isboxer.com/index.php/component/ ... -computers
Naturally I also see no detection of computers in ISBoxer...
So is there some limitation on the trial or could there be some other issue?
I wondered if I should ignore the fact that right click "Computers" shows "No remote computers detected" and continued following the instructions, creating a pair of computer entries and proceeded through the documentation. I get to the part where it reads:
Right click on Computers and select <All Computers> in the Copy + Export all to remote Inner Space sub-menu.
and theres no <All Computers>.
Am I right in thinking that at the point where I click "Start Multiple Computer Helper" on both machines there should be network traffic?