Repeater Region at 0,0 offsets itself on load
Posted: Fri Jan 09, 2015 9:18 pm
If I have a repeater region which is set to be positioned at 0,0, when it is loaded it offsets itself to 200,50, displacing it.
e.g.
I set the region up as
when it loads it turns up at
If I setup the region at 1,1, or -1,-1 there is no offsetting. The offsetting occurs on the respective axis even when only one of the X or Y co-ords is 0.
e.g.
I set the region up as
when it loads it turns up at
If I setup the region at 1,1, or -1,-1 there is no offsetting. The offsetting occurs on the respective axis even when only one of the X or Y co-ords is 0.